DOS pump not priming

[reeferericb]

My AWC DOS pump is having issues on one side. The pump that adds fresh saltwater isn’t able to pull water up the line. It tries and loses suction. The water never makes it more than an inch up the line before dropping. Any suggestions?

 

[Spieg]

Must be an air leak or the pump rollers are not squeezing the tube enough.

 

[reeferericb]

I’ll try a shorter piece of tube and see if the one I’m using has a hole in it somewhere. Thanks for the tip.

 

[SuncrestReef]

It's possible the tubing doesn't have an air-tight seal on the DOS fitting. I always soak the tubing in near-boiling water to soften it right before connecting to the DOS.

 

[reeferericb]

It’s been working for about a year until a couple days ago. I do think it’s the rollers not making good contact, is there a way to fix that? It makes a weird popping noise when running that none of my other pumps make (I have two DOS units).

 

[reeferericb]

I tried a short piece of pipe and the issue persists, that’s why I’m pretty sure it’s the pump head.

 

[Spieg]

Pretty sure they sell replacement heads.

 

[Hairyteeth]

Pretty sure they sell replacement heads.

They do, super easy to replace. Just snap on and off

 

[homer1475]

Just did this with my DOS. Think they are like $26 on BRS. They are the entire head with rollers and tubing.

DOS Replacement Pump Head

Direct replacement fluid metering head assembly for the Neptune DŌS Dosing Pump. The easy to install head replaces the tubing, roller, and plastic housing head cap. Compatible with DŌS and DŌS QuietDrive Installs in minutes Replaces wearable tubing The Neptune DŌS Replacement Head assembly...

www.bulkreefsupply.com