Drilling a brute

[Deezill]

question for you guys. i have uniseals for my brute and they are 3/4 i got the BRS hole saw kit. the 19mm make a hole way too small for the uniseal to go inside.
am i to try to push a 3/4 uniseal in a 19mm hole? I'm confused any help would be great. thanks.

 

[lapin]

http://cdn.barrplastics.com/WWW/05+WW/08+PVC+SEWER+DRAIN+VENT+FITTINGS+%26+PIPING/Uniseal+Install+Guide.pdf

BRS

¾” Uniseal
Fits our schedule 80 ¾” pipe
Pipe ID – ¾”
Holesaw size: 1 ¼” or 31.7mm (32mm)

 

[DopamineKata]

Their website says to use a 32mm hole saw for a 3/4 uniseal...

 

[Deezill]

yep i went to thier site after i posted this felt sill and used my 32mm and works great lol thanks.

 

[DopamineKata]

yep i went to thier site after i posted this felt sill and used my 32mm and works great lol thanks.

Don't feel too bad. When I drilled the holes for the plumbing to go through the top of my stand I went out and bought a hole saw for it. Turns out it was big enough for the pipe but not for the pipe with a fitting on it. I already owned the right hole saw for pipe + fitting.

 

[Deezill]

Don't feel too bad. When I drilled the holes for the plumbing to go through the top of my stand I went out and bought a hole saw for it. Turns out it was big enough for the pipe but not for the pipe with a fitting on it. I already owned the right hole saw for pipe + fitting.

lolol. Thank you i needed that lol.