I purchased a new energy bar and was able to move all my programming to the new energy bar except my ATO. I've had some issues with my ATO working since I set up a 60 gallon reservoir in my basement and have been using peristalsis pump to pull the water up from the basement and top off my sump. With my old energy bar the peristalsis pump would not turn on automatically but i could turn it on manually to top off my sump. Since I switched to the new energy bar the outlet the peristalsis pump is plugged into on my new energy bar is not showing up in my apex. I have checked and all my modules are updated and fine. All my other equipment is working fine. On the new energy bar outlet 4 and 7 do not show lights. These are the only outlets left empty. What am I doing wrong? Thanks to all.
EBB 832 question
- Thread starter Deborah Armay
- Start date
- Tagged users None
Pistondog
5000 Club Member
- Joined
- Jun 28, 2020
- Messages
- 5,470
- Reaction score
- 9,581
If you click on the lock in the app, any unused ports show at top.
If you press the watts display for the ebb itll show the labels for the outlets in case it is mislabeled.
Hope this helps
Deborah Armay
Active Member
- Joined
- Jan 10, 2019
- Messages
- 135
- Reaction score
- 52
It did. Thanks so much.
