Ecotech on 2 tanks, wireless issue???

[CheckeredPants]

I have an MP10 on my nano cube. I have two MP40s and a Vectra L2 on my 130g which is cycling. Today I put my MP10 in Feed Mode And this caused my Vectra and MP40s to run half speed and at first I had no idea what was going on. Only when my ATO alarmed did I realize something happened, and I realized the MP10 sent a signal to the other devices and everything went into Feed Mode. This sent me into panic mode since I didn’t know this would happen. I do not have a Reef Link.

Is there a way to stop this from happening?

 

[AdamNC]

Factory reset the MP10. This way it’s independent of the others. Somehow you might have linked them all. Only thing I can think of.

 

[ReefRondo]

Have you added the MP10 to a new tank profile or just got them all running together? You’ll need to add it to a new tank in Ecotech live so it runs independently.

 

[CheckeredPants]

Factory reset the MP10. This way it’s independent of the others. Somehow you might have linked them all. Only thing I can think of.

I’ll have to try that. It was my first time using feed mode in the nano since putting the other equipment on the larger tank.

Have you added the MP10 to a new tank profile or just got them all running together? You’ll need to add it to a new tank in Ecotech live so it runs independently.

I don’t have a reef link, and I think the “profile” you’re mentioning is in that interface correct?

The MP10 has been running for a couple years on my nano. Last week I installed the MP40s and Vectra on a new tank and this was my first time using feed mode on my nano since doing so.

 

[ReefRondo]

Sorry I forgot to ask if you had a reeflink.

 

[Reefltx]

Did You somehow linked them?
I run the vectras and MPs too, and they do not auto link.

 

[CheckeredPants]

Did You somehow linked them?
I run the vectras and MPs too, and they do not auto link.

If I did, I have no idea how I did it. All I did was plug in the equipment on the new tank.

Do you know how I could have even done that? Or how to undo it?

 

[CheckeredPants]

When I realized what happened I took the MP10 out of feed mode and all the other tanks equipment went back to normal too.

 

[Reefltx]

You can try to reset each power head.

https://ecotechmarine.com/wp-content/uploads/2016/07/QuietDrive_FullManual_Final_102517.pdf

 

[CheckeredPants]

You can try to reset each power head.

https://ecotechmarine.com/wp-content/uploads/2016/07/QuietDrive_FullManual_Final_102517.pdf

What’s crazy is I never set any of them up as master, slave, or a group. I found the section on resetting and will give it a whirl.