Ecotech radion xr15 g4 pro fried wire to pre-driver

[SilentNight1793]

I have had the xr15 g4 pro for a while and have loved this light. Yesterday I noticed it had stopped working. I checked the outlet, power supply and so on to make sure everything was good. I opened the bottom panel where the puck is to check the fuse and it was good as well. I noticed the wire from the power cable was a little melted and inspected it more. The piece that plugs into the pre-driver board had melted and burnt the wires. Is there any way to order new pieces to repair this?

 

[SilentNight1793]

 

[crawling junk]

If you cant find the pieces, you can always solder the wires directly to the board

 

[r21]

Did you manage to fix this? I have the same issue on a spare light but would be good to get it fixed for new tank

 

[Branespikin]

Reviving old thread. Have the same issue. Anybody fix this? Replacement parts?

 

[somethinq else]

I had the same issue with my g4 30 pro and sent it back to ecotech to be repaired because I wasn't sure what the issue was. They charged me 300.00 for the repair of a replacement driver us 10.00 to ship, stating normally that repair is 370.00 plus shipping. Ki day he also ga e me the opportunity to purchase a new g5 for 500 plus dollars. I was shocked to hear it would coat that much to replace a part inside this thing. I was expecting half that at most.