Hey all got my first printer over the weekend an Ender 3 v2. Ive printed a couple things (1 hour to 4 hour prints) and minus some bed adhesion issues all went well. Tried to do an 8 hour print overnight and it failed at about 60%. I had put a spare wyze camera on it and discovered at 12:30 it stopped printing and put the bed back at 0 for one hour then tried to resume printing where it then became detached. What would cause the print to stop for an hour then try to resume?
Ender Printer Problem
- Thread starter Waffen06
- Start date
- Tagged users None
Ron Reefman
Lets Go Snorkeling!
Reef Squad
Excellence Award
Reef Tank 365
Article Contributor
Tampa Bay Reef Keepers
MAC of SW Florida
I'd suggest you'll have far better luck asking the manufacturer.
NeonRabbit221B
2500 Club Member
+1 on asking manufacturer. Not familiar with the Ender but I know its similar to Prusa MKs. Take a pic of the print that failed please.
