Esv b-ionic

[Rmckoy]

I have been using b-Ionic 2 part for awhile and like it .
however . I bought the large gallon jugs which are concentrated .
The instructions say to fill with rodi water .

that’s easy , but next issue . The alkalinity part has went hard .
if i can break it up to dissolve will it still be good ?

 

[BigKid4788]

Put the amount of RO water needed and then put a heater and power head in it until it fully dissolves. It’s still good

 

[Rmckoy]

Put the amount of RO water needed and then put a heater and power head in it until it fully dissolves. It’s still good

I will be able to add rodi water .

but getting the larger chunk out . Or a heater and power head in the container might be a issue …

 

[FREAKINRICAN69]

It’ll still be good. Just add the correct amount and shake and leave 24-48 hours before use. Also shake every time you go to use it. Gl

 

[Tumey]

I use B-ionic as well. I’m in Iowa and during the cold months the Alk is usually hardened on arrival. It’s taken as long as a week of shaking the concentrate daily before all the chunks are completely dissolved.

 

[Pistondog]

I will be able to add rodi water .

but getting the larger chunk out . Or a heater and power head in the container might be a issue …

Put it in a 5 gallon bucket of hot water and shake every 15 minutes or so, replace water with new hot as reqd.

 

[Thuan]

I’m in Colorado. Been using esv for a long time. I put it near the heater in the winter or outside during the hot summer months. Shake it a few times, and it will dissolve after a few days

 

[reefiniteasy]