Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Thanks! This is all a while ago. I slowly added trochus over time. I did 4 at first and fed them seaweed until my algae bloomedSweet setup! I would have waited to added the cuc just because there’s not a lot of algae for them to eat so they might starve and die off. Wish I kept my tank bare bottom or went with heavier sand like aragonite lol so much easier to maintain than the regular sand.


8/19 lets relax and be consistent
As you can see below my salinity is a little higher. No problem I say. My sensor is about to top off and lower it a little. My insomnia is kicking in and my ATO just finished kicking on. Firstly I realize it was not able to finish flilling because the reservoir and pump are too far below the tank. I go to measure my salinity. Its 1.05. Whaaaat!! I check 5x more...how could this be? I check my ATO water. My ATO is measuring 1.026... At this point I'm thinking Dong messed up with calibrating my refractometer. I check 5 more times and realize this is from when my pump back siphoned a bunch of water. Luckily just the night before I had created 30 gallons of ro/di water. I change resevoir and bring salinity down to 1.026. And I put the resevoir higher so it can actually fill the tank. The tube for ato is above the maximum waterline so i had forgotten that event occurred...now let's see how the tanks doing
40 Breeder
08/19 Monday 08:33 PM
Temperature: 77 °F
pH: 8.1
Nitrate: 25 ppm
Phosphate: .25 ppm
Salinity: 1.029 SG
Alkalinity: 8.4 dKH
Calcium: 425 ppm
Magnesium: 1275 ppm
Are you topping off your tank with rodi water or salt water?

