Flow in 93 cube

[bucksfan1976]

I can't find a good power head placement for my cube , I seem to have some dead spots, I have a lot of sps so flow is vital. I am running 2 Jabeo wp-25s, both set on 75% wave mode not synced
Here are my thoughts please chime in

1. Add a little more rock to get corals up more in the flow area

2. I'm clueless lol

Here is a pic I took today

 

[Reefing Madness]

You could always get some of the little power heads and get them into the low areas that aren't getting any flow.

 

[SeahorseKeeper]

I would open the rock work up more. It seems to be jammed a bit which will restrict the flow.

 

[PaulKreider]

I'd get two smaller 1050 or 750 koralina pumps, put one on back and one lower on wall, and have them on off with a smartwave.

 

[bucksfan1976]

Ill have way to much flow then I'm gonna redo rock work

 

[zero]

You can offset the powerhead one higher than the other should push the flow to area needed. Flow going head on will just cancel most of the wave out. Just my opinion.

 

[Reefing Madness]

Ever thought of something like these on a powerhead? It directs flow where you want it.
Circulation Pump Wave Maker 1600 GPH Aquarium Reef Powerhead Suction Cup Mount | eBay

 

[bucksfan1976]

I actually had those on my 150 the ones made be reef octopus. I figured it out by placing both on the same side, redoing the rock work I'm thinking I'm good. I keep one running 24/7 at 75% percent, when my t5s kick on the 2nd one kicks on at 75% both run til my t5s kicks off. Thanks for all the help!!!!