Fluval Evo 13.5g and Kraken Lid

[Dave Clark]

Hello. I have a Kraken lid on my Fluval Evo 13.5g. I'd like to find chamber lids that will fit when the Kraken Lid is on.

I got the 3dOcean chamber lids which are nice, but they don't fit with the Kraken Lid. I could dremel them down but I'd rather have a clean look, which I can't seem to get with a dremel. ;-)

Thanks in advance.

 

[blaxsun]

You may need something custom.

 

[Dave Clark]

You may need something custom.

I thought about that, though it also seems to me that a lot of Fluval Evo owners with Kraken lids might have wanted to do the same thing, and so there would already exist chamber lids that would fit.

 

[blaxsun]

I thought about that, though it also seems to me that a lot of Fluval Evo owners with Kraken lids might have wanted to do the same thing, and so there would already exist chamber lids that would fit.

The way the Fluval Evo is designed doesn't lend itself well to most lids, ie: they fit but only when you remove the second piece over the chambers. I've looked around from time to time and I haven't found anything. Still looking...

 

[Deep sea reefer-240]

I have a lid from Reef print so I imagine its very similar

Fluval Evo Chamber Lids

These D-Flow chamber lids help you create a neat and tidy way of covering up the tops of your Fluval Evo back chambers are you replace the stock lid on the system. They come with cutouts to allow for chamber 2 light mounts and cables from your pumps and heaters in chamber 3.

dflowdesigns.com

I bought these and they have fit with my lid

Hope this helps

 

[Dave Clark]

Hey, in case anyone happens upon this thread with the same question ... I wound up getting these, and they fit perfectly (solid build, too):

Evo 13.5 Chamber Lids

Three separate lids to cover the chambers on your Fluval Evo 13.5 aquarium when used without the stock lid. Helps with an open air aquarium setup. Wire slots are molded into the covers for chambers two and three.

fishguildcorp.com