Gap between rimmed 80g breeder and stand.

[rahger]

Hi all. My friend messaged me about a small gap between the rim of his 80g tank and the stand. From how he explained it’s just near the edge and it’s smaller than a quarter’s width.

he thinks the stand may have warped slightly when he moved the stand into the basement where he has a larger aquaculture system.

my gut says to drain the tank and redo the stand top to see if it’s the stand that’s warped rather than the table’s rim.What do you guys think he should do?
I’ll try to get a pic of the gap soon.

 

[Hendrix]

Gap is ok if supported by the four corners. If one of the corners are raised it's a problem. Pics are always good

 

[Reeffragger]

As stated its the 4 corners that need supported AND the middle if its a 6ft long tank. But the 4 corners are the most important. This is for tanks with trim