GCC Fill Water Options

blfuller123 · Dec 28, 2019

I currently use Fill Water as a function for my auto top off pump that is mounted in my stand. I have it set with a delay turn on and I have it set to run for up to 2 minutes and this works well for me.

I am adding a power bar next to my mixing station in another room and plan on moving this ATO pump there. I was configuring the new ATO socket on and planned on using the same functions that it was already when I noticed in GCC that there are 3 different fill water functions. I know one is for ATO and one is for AWC and the third just says Fill water. I have been using the one listed as Fill water but was wondering what are the differences between functions Fill water, Fill water (ATO Only), and Fill water (AWC Only)?

Ditto · Dec 30, 2019

@Vinny@GHLUSA

Maybe a support ticket on it also?

AZMSGT · Dec 30, 2019

Good darn questions.

Vinny@GHLUSA · Dec 30, 2019

Fill water - For general ATO, Leak Detection, Return pump function purposes
Fill water (ATO only) - For general ATO purposes or when AWC & ATO function is used.
Fill water (AWC only) - For water change purposes.

blfuller123 · Dec 30, 2019

Vinny@GHLUSA said:
Fill water - For general ATO, Leak Detection, Return pump function purposes
Fill water (ATO only) - For general ATO purposes or when AWC & ATO function is used.
Fill water (AWC only) - For water change purposes.

So do the function differently or do they just have different names?