gen 1 mp10 not working??

sutton6989 · Jan 12, 2013

so i have a gen1 (blue box) mp10 that just stopped working.. when u plug it in it blinks (2 green blinks, 2 blue blinks, 1 white longer blink) then goes to the regular setting green light and then the light turns off and theres a faint barely lit white light and the pump never turns on.. anyone have this problem.. LMK please

ladyreefer1983 · Jan 12, 2013

i have this problem also...tagging along..hope someone can help us

sutton6989 · Jan 12, 2013

well i just confirmed its not the dry side because i hooked it up to a new controller and it works flawlessly.. it must be something with the controller.. does anyone know how to reset these or something?

peterthegamer · Jan 12, 2013

Would call the company about it.

fragmatic · Jan 12, 2013

Wait, do you have two? Is one trying to be in slave mode? I only have one VorTech MP-10, and I'm a bit confused with the differences between mine and the gen1 models. I have my booklet, and am looking to see what it says if it helps. I don't know how to edit in this forum, so I will post again in a few.

fragmatic · Jan 12, 2013

I tried to find a picture of your model and was not able to find one. If it applies try this: press and hold down both the mode and set buttons, then hold down the mode button, then hold down the set button. This sequence should reset the control. You will have to re select your mode after that.