Gen4 Xr30 Pro Optic Lens melted

[cymaster007]

Anyone else have this happen? I just got the new Radions in and was programming them on ecosmart live, had the light resting on my light rail, when I picked up the light to move it I noticed a burning smell and saw this on the optic - melted where it was touching the rail. Are they supposed to get hot enough to melt the lenses?

 

[Cherub]

That's an expensive mistake. I've seen other similar threads. Sorry for the loss

 

[cymaster007]

That's an expensive mistake. I've seen other similar threads. Sorry for the loss

I never saw this issue on the Gen 3 fixtures

 

[sn2per]

Wow... have you contacted Ecotech directly?? If so what was the result??

 

[Jason_MrFrags]

You set it on something while running??? You might of been lucky and can get away with just replacing lens if an led didn't melt

 

[cymaster007]

Wow... have you contacted Ecotech directly?? If so what was the result??

I sent Ecotech photos and they promptly sent out a replacement lens. I swapped it out and the fixture is back to normal

 

[cymaster007]

You set it on something while running??? You might of been lucky and can get away with just replacing lens if an led didn't melt

Yes, the fixture shifted a few inches while I was tinkering with the initial programming, (which defaulted the fixture to 100% all channels while I adjusted the program) It was just the lens that melted, luckily it was not on anything flammable

 

[iriemon]

found this old thread in a panic...yes i did the same thing

burnt up 2 lenses

contacted and they are sending them out for shipping cost!!
U ROCK!!