Green birdsnest err uhm white birdsnest.

Elwood Dowd

Active Member
View Badges
Joined
Mar 4, 2017
Messages
127
Reaction score
184
Location
At home with velvet, bryopsis, and dinos
What state or country do you live in
Florida
Rating - 0%
0   0   0
I have a green birdsnest frag about 2.5 inches tall, nice metallic green polyps with brown tissue. The polyps have turned stark white.

At the LFS the tissues were a bit tan. However they have darkened substantially. There is no tissue necrosis at all. It's growing quite well and I have great polyp extension. It was placed just off center of the light and 5 inches below the surface of the water. I do not have a par meter. But, it was getting blasted with light.

I haven't neglected my water. But, I have avoided looking at my tank because I am in the middle of fighting bryopsis.

My rig is a 40b peninsula with a 20 long sump, 250w 14k MH 8.5 inches above the water, and a 7 hour on time. I have 540 gph turnover and 1600 gph flow. Temp is 78 and fluctuates about + 1.5 degrees after the lights come on. Then back to 78 where it remains.

Water parameters are:
Sg 1.024
Ph 8.4
Dkh 8
Cal 420
Mag 1300
Phos 0
Ammo 0
Trite 0
Trate 0

With polyps changing to white with good water and tons of light. Was I cooking it or is the bryopsis depleting my tank of nutrients needed for sps to maintain color? (My Montis are looking good and colors are getting stronger, both tissue and polyps)
 
I moved it back down to the sand 2 days ago just in case that was the issue. The leap from zoa's, acans, and lps to sps has been a tricky one for me.

Thanks for the input!!!
 
If there is a lot of Bryopsis, then a lot of nutrients may be getting consumed. High light and low nutrients is not a good combo. I have found corals have done well for me in high light but when the nutrients dropped, it was suddenly too much light.

I have Green Bird's Nest that grows very well for me. It seems more resistant to alk swings then other BN but seems to like a little bit less light. 150-250 par seems to be a happy place. Some of mine is 300 plus, but does not look as full. I think that light and nutrients are tied together so it is important to mention that I like to keep 5-10 Nitrates and .03-.08 Phosphate.

I just noted your N and P are zero. In my opinion, this makes high light difficult for many corals.
 
Can you manually rip out the Bryopsis? This may allow nutrients to go back up .

"With polyps changing to white with good water and tons of light. Was I cooking it or is the bryopsis depleting my tank of nutrients needed for sps to maintain color? (My Montis are looking good and colors are getting stronger, both tissue and polyps)"

The answer is probably both. I think of hitting a lot of light as like stepping on the accelerator of your car. If you do, then the motor better be getting an increased flow of fuel [nutrients] to meet the demand. If not, you kill the motor. If a motor is run too lean it will eventually overheat and burn up the motor. I think it is the same with coral.
 
I'm in the middle of dosing fluconazol for the bryopsis. Also, just 1.5 weeks ago I pulled all of my rocks out and scrubbed then rinsed in old water change water. The bryopsis came back stronger than ever.
 
When you removed the Bryopsis the nutrients probably went up some. The remaining hidden pieces of Bryopsis loved it and flourished.

Hope the treatment works.

If not, do you have a sump? If so , is it possible to place all your rock in the dark in the sump? Leaving your corals up top.
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 30 44.8%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 13.4%
  • No.

    Votes: 25 37.3%
  • Other (please explain).

    Votes: 3 4.5%
Back
Top