Help adding ATO pump to [Maintenance/Power Cut] button?

[TigerReef]

Hi! I am finally setting up my [Maintenance Button] on GHL Connect. I know... But better late than never, right?

Ideally, what I'd like to do is have my Skimmer [Switch Channel 1], my ATO pump [Switch Channel 2], and my ClariSea [Switch Channel 7] all respond to [Maintenance Button 1] for 60 minutes. Skimmer and ClariSea are no problem. Done.

But my ATO pump [Switch Channel 2] is already set to Function: Fill water ATO only responding to Level Sensor 1.

I think I need to add Programmable Logic for the Maintenance 1 function to include the ATO Pump [Switch Channel 2] correct? But how do I set that up without overriding the ATO functionality?

@Lasse do you have ideas to solve this?

 

[Lasse]

I´m not sure but I think that your settings in picture 1 will override the ATO function during the time maintenance 1 is active - no need of change the function in switch 2 at all. Test

But if it not work - try this PL

Fill water only 1 and maintenance 1 (inverted)

Sincerely Lasse

 

[TigerReef]

I´m not sure but I think that your settings in picture 1 will override the ATO function during the time maintenance 1 is active - no need of change the function in switch 2 at all. Test

But if it not work - try this PL

Fill water only 1 and maintenance 1 (inverted)

Sincerely Lasse

@Lasse I will try it! Many thanks!

 

[TigerReef]

@Lasse Yes, you are correct! My settings in picture 1 will override the ATO function during the time maintenance 1 is active - no need to change the function in switch 2.

As always, thank you again for your help. I hope you enjoy a happy and safe holiday!