Help, Apex feed mode program with Hyrdos WaveEngine2 & APX Link cable

[BryanM]

Hyrdos sent me this link, which I followed, but when I activate feed mode the powerheads in the tank just stay on.

Activate Feeding Mode - HYDROS

www.coralvuehydros.com

Step 3 is "off", in so much as its referencing 4 inputs where there were only 2, so it is confusing.

 

[BryanM]

FYI, this is resolved.

For anyone that runs across this:

1) CoralVue support was very helpful, and resolved this over the phone in about 10 minutes.
2) In the outputs, selecting a powerhead, there's a dropdown "Active in modes", where you can select 3 things: Feeding, Normal, Water changes.

For some reason all 3 were selected. Basically preventing anything from changing, since I told it that they powerheads were to always be on.

 

[n2585722]

FYI, this is resolved.

For anyone that runs across this:

1) CoralVue support was very helpful, and resolved this over the phone in about 10 minutes.
2) In the outputs, selecting a powerhead, there's a dropdown "Active in modes", where you can select 3 things: Feeding, Normal, Water changes.

For some reason all 3 were selected. Basically preventing anything from changing, since I told it that they powerheads were to always be on.

The outputs usually default to active in the different modes when created so you will need to uncheck them in the modes you do not want them active in. You can also set this in the settings for the modes as well and the individual output settings.