I just returned from a 10 day vacation, during which I had someone coming by to feed the fish every 2-3 days (I pre-measured food so there should not have been an overfeeding issue while I was gone). When I got back, 4 of my SPS frags were bleaching at either the base or the tips, with about half of each frag damaged/tissue gone. As of this morning, another SPS frag, which was fine last night, is half bleached/gone. The other 7 SPS frags are fine, and the 2 LPS frags/colonies are fine.
I checked all the lights, ATO, pumps and other equipment and all seems fine.
Here are the measurements as of this morning, with my usual parameters/targets in parentheses following:
Temp: 77 degrees (same as usual)
SG: 1.024 (usually 1.0245 or 1.025)
Calcium: 425 (same as when I left, usually closer to 450 though)
Alkalinity: 8.5 (usually between 8.6 and 8.9, but I've had larger swings than this with no issue)
Phosphates: 0 (same)
Nitrates: 0.2 (same)
Magnesium: 1320 (same)
So far I have not done any water change because my RO/DI unit adapter isn't working properly and I can't get the connection to the sink to work (when I do get it working I can only make a small amount of water, perhaps a gallon in 3 hours, because I have to keep the water pressure low to keep the adapter from breaking. I ordered a new one but that doesn't help me right now). I do not run carbon or GFO or anything, and have not added anything other than 2-part Calcium/Alk additive, and I don't run a skimmer.
Anyone have any ideas on what could have caused this or suggestions for damage control?? I will also do a water change as soon as I can mix more water.
thanks
I checked all the lights, ATO, pumps and other equipment and all seems fine.
Here are the measurements as of this morning, with my usual parameters/targets in parentheses following:
Temp: 77 degrees (same as usual)
SG: 1.024 (usually 1.0245 or 1.025)
Calcium: 425 (same as when I left, usually closer to 450 though)
Alkalinity: 8.5 (usually between 8.6 and 8.9, but I've had larger swings than this with no issue)
Phosphates: 0 (same)
Nitrates: 0.2 (same)
Magnesium: 1320 (same)
So far I have not done any water change because my RO/DI unit adapter isn't working properly and I can't get the connection to the sink to work (when I do get it working I can only make a small amount of water, perhaps a gallon in 3 hours, because I have to keep the water pressure low to keep the adapter from breaking. I ordered a new one but that doesn't help me right now). I do not run carbon or GFO or anything, and have not added anything other than 2-part Calcium/Alk additive, and I don't run a skimmer.
Anyone have any ideas on what could have caused this or suggestions for damage control?? I will also do a water change as soon as I can mix more water.
thanks


