Ok so I am doing a water check on my Biocube (filling it up with water then draining it just to make sure it holds water) and just have a question. So when I fill my tank up to the top do I independently add water to the sump too? Also should I even add water to the sump for a water check? Sorry if these are dumb questions but I just want to make sure.
Help with Biocube 32 again
- Thread starter Fishbro
- Start date
- Tagged users None
BarSnackz
Active Member
I'm not familiar with those tanks but it looks like an AIO (all-in-one) tank, right? Water goes into the back section and then gets returned on the other side of the back after hitting the filter media. You'll need to manually remove the water from the back section. Whether it be siphoning it out or just pick the tank up and flip it over to drain it.
Unless there is a little emergency drain hole in the back wall at the bottom to allow water to flow out like the Evo 13.5's have.
Unless there is a little emergency drain hole in the back wall at the bottom to allow water to flow out like the Evo 13.5's have.
BarSnackz
Active Member
No problem. Only thing I would be afraid of when turning on the return pump when all the display water is out is running the pump dry if the water level gets too low when trying to shoot the excess water back into the display.
