Help with my 55 gallon reef tank before I drain it

CrystalReefJunkie

New Member
View Badges
Joined
Dec 23, 2021
Messages
22
Reaction score
19
Location
Bridgton
What state or country do you live in
Maine
Rating - 0%
0   0   0
Ok everyone I need some advice and help before I go bald from pulling my out over this one tank. My 55 doesnt seem happy and I'm not sure if it's a lighting issue or flow. The tank in question is my profile picture right now.

I have a 55 gallon tank with single over flow in the back left corner of the tank with a 20 long refugium sump. I have DsunY led reef lights on the tank (which is where I think I messed up). In the tank I have 2 small powerheads and 1 big wavemaker powerhead along with the return line. Livestock right now is a yellow watchmen goby, a snowflake clown, 2 turbos, few sand snails, hermit crab, barnacles, featherdusters, shrooms, gsp, kena, cabbage, finger leather, palys, zeina, flower pot, duncan, favia and a brain.

The ducan, palys and finger leather will not open no matter where I put them in the tank but will open in my other tanks. Flowerpot started opening after putting it in a shady spot and the gsp, cabbage and Kena open everyday no matter what. I don't get it.

Has anyone here used Dsuny lights before? Not sure if I don't have them setup right or if it's the water flow
 
i am not too familiar with those lights but it could be a number of factors.

What are the dimensions of the tank? Tank depth could play a factor with the next question
How high are the lights off the surface of the water?
How high are the lights turned up? They seem capable of producing enough par if you have them turned up
Have you measured Par at all?

What are the parameters of your tank?
 
20220101_133202.jpg
Screenshot_20211201-130826_Chrome.jpg
Screenshot_20220101-133031_Turing.jpg
Screenshot_20220101-133035_Turing.jpg
Screenshot_20220101-133040_Turing.jpg
Screenshot_20220101-133047_Turing.jpg
 
You nitrite at .1 should be at zero. Once the tank is fully established (cycled), the bacteria should be processing the ammonia and nitrite almost immediately.

Phosphate at 0 is a little concerning. Typically .03 to .07 is recommended. That could be causing the issue. That being at 0 could be starving your corals.

All other parameters look good/are acceptable. Some will tell you that your Nitrate is high (but I have had no issue keeping my Nitrate at higher levels (20-25 range).

As for the lights, they look capable enough and put out enough energy, but you would need a par meter to measure the light penetration at certain spots and depth of your tank. Those spectrum values that you posted are what the light is capable of, not necessarily what the penetration of light is on your tank. You would need a Par measuring tool to actually measure the Par values. You can rent them, but I don't think that is your issue.

If I had to guess, I would think it is the phosphate being too low.
 
You nitrite at .1 should be at zero. Once the tank is fully established (cycled), the bacteria should be processing the ammonia and nitrite almost immediately.

Phosphate at 0 is a little concerning. Typically .03 to .07 is recommended. That could be causing the issue. That being at 0 could be starving your corals.

All other parameters look good/are acceptable. Some will tell you that your Nitrate is high (but I have had no issue keeping my Nitrate at higher levels (20-25 range).

As for the lights, they look capable enough and put out enough energy, but you would need a par meter to measure the light penetration at certain spots and depth of your tank. Those spectrum values that you posted are what the light is capable of, not necessarily what the penetration of light is on your tank. You would need a Par measuring tool to actually measure the Par values. You can rent them, but I don't think that is your issue.

If I had to guess, I would think it is the phosphate being too low.
Thank you for you time and input. I'll look into renting a par meter. The tanks been up and running for about 3 years but I just recently put the new lights and refugium sump on it. Would the new sump make it cycle?
 
I don't think the addition of the sump would cause any issue.

What brand tests are you using? API tests can give you false readings. You might actually have 0 nitrite.
 
I used Chinese black boxes over a 55 gal for years with no issues at all and they were only 165w. I grew coral like crazy I had them 12 inches above the water ran blues at 100% and whites at 50%. The lights are more than powerful enough maybe have them up to high?
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 30 44.8%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 13.4%
  • No.

    Votes: 25 37.3%
  • Other (please explain).

    Votes: 3 4.5%
Back
Top