Help with RODI solenoid programming

[JCOLE]

I currently have a solenoid on my RODI unit that turns on when my float valve in my 45 gallon ATO reservoir gets low. I just made a switch from Kalk to regular fresh water. I used to fill up 5 gallon buckets at a time for Kalk. Now I have another solenoid attached into my reservoir which constantly fills my tank when top off is needed. My RODI reservoir has been running flawlessly for 6 months. However, now that my RODI is constantly fluctuating to fill up my reservoir I would like to make a change. I want my RODI to only activate between the hours of 8pm to 1am to fill up my reservoir. I only also want it to run during this time if my reservoir float switch is closed.

I set up a time to my programming but it still kicks on outside of the time because the switch is closed.

Fallback OFF
Set OFF
If RODI_S CLOSED Then ON
Defer 000:10 Then ON
When On > 580:00 Then OFF

Any help would be appreciated. Thank you.

 

[Biglew11]

Fallback OFF
Set OFF
If RODI_S CLOSED Then ON
Defer 000:10 Then ON
When On > 580:00 Then OFF
If time 01:01 To 19:59 Then Off

This last line tells it to stay off between 1a.m. and 8p.m.

 

[JCOLE]

Fallback OFF
Set OFF
If RODI_S CLOSED Then ON
Defer 000:10 Then ON
When On > 580:00 Then OFF
If time 01:01 To 19:59 Then Off

This last line tells it to stay off between 1a.m. and 8p.m.

Ok thank you. Will it automatically turn on between 8pm-1am or will it wait for the float switch during that time? I only want it to run if the switch is bbn open during that time.

 

[Biglew11]

It will only activate if the switch is closed the if time statement only tells it to stay off.
Also you might change the when on 580:00 to 4hours or something just over what it takes to fill your resivior.