Household temperature

BillyN

Community Member
View Badges
Joined
May 29, 2017
Messages
31
Reaction score
17
Rating - 0%
0   0   0
I started my tank in January but have not changed my house programmable thermostat settings - 72F during typical wake time and 70F during typical sleep time. Of course my tank fluctuates accordingly (with lag) from 80F to 78F. Two questions: What do you experienced aquarists do with your house programmable thermostats? Do temperature swings affect PH?
 
I started my tank in January but have not changed my house programmable thermostat settings - 72F during typical wake time and 70F during typical sleep time. Of course my tank fluctuates accordingly (with lag) from 80F to 78F. Two questions: What do you experienced aquarists do with your house programmable thermostats? Do temperature swings affect PH?
Ph not affected by temp if your tank is small house temp can affect it more easily also direct light. My tank will raise and lower a few .10's each day I run my thermostat with a few degs fluctuation like you also
 
I started my tank in January but have not changed my house programmable thermostat settings - 72F during typical wake time and 70F during typical sleep time. Of course my tank fluctuates accordingly (with lag) from 80F to 78F. Two questions: What do you experienced aquarists do with your house programmable thermostats? Do temperature swings affect PH?
Are you struggling with low PH?
If so what is your PH at right before lights out?
 
Lights and alkalinity affect pH more than temp. Is the tank affected by the temp fluctuations?
 
Are you struggling with low PH?
If so what is your PH at right before lights out?
Thanks all. I asked about PH because it is only parameter whose fluctuation I don't understand (Ca 420 to 440, dKH 9-10, Phosphates and Nitrates not detectable). I test PH early evening +6 hours after tank lights come on (sump light on when tank lights not) and ranges from above 7.8 to below 8.2 (I struggle with the test colors).
 
Thanks all. I asked about PH because it is only parameter whose fluctuation I don't understand (Ca 420 to 440, dKH 9-10, Phosphates and Nitrates not detectable). I test PH early evening +6 hours after tank lights come on (sump light on when tank lights not) and ranges from above 7.8 to below 8.2 (I struggle with the test colors).
Is this what your looking for to help you understand?
Just start at the top and take it all in.

http://www.reefkeeping.com/issues/2004-09/rhf/
 
I'm going to try the aeration test this weekend.
Lol,
I open my widows all the time and my ph stays up. (but your 7.8 to 8.2 is not bad.)
I open two windows and one blows the trapped in Co2 out with a fan.
Turn on all ceiling fans and leave the thermostat temp alone but switch the fan from auto to "on", until I close the widows.
When it's hot in the summer then I open my windows overnight while the outside temp is cooler.
 
If you don't mind let us know what Randy's Co2 aeration test results come to over the weekend.
 
My nano always had the same pH as your tank. My new 40g in the same room has a consistent pH of 8.2-8.3. My theory is that the skimmer on the 40g keeps the tank aerated.
 
I started my tank in January but have not changed my house programmable thermostat settings - 72F during typical wake time and 70F during typical sleep time. Of course my tank fluctuates accordingly (with lag) from 80F to 78F. Two questions: What do you experienced aquarists do with your house programmable thermostats? Do temperature swings affect PH?
My thermostat stays on 72 when Im home but will fluctuate when Im not home. I haven't seen a pH change due to it
 
If you don't mind let us know what Randy's Co2 aeration test results come to over the weekend.
I decided to skip the test after reading glb's post.
You both lead me in the right direction- pretty sure inadequate aeration was issue with PH fluctuations. Last night opened my oveflow line choke valve a little to allow a little gurgle in my overflow box so air gets entrained in the water as it flows down to the first section of sump. Tested ph two hours later and it was 8.2. Checked again this morning before lights on and tested on + side of 8.2.

I had incorrectly assumed my skimmer provided enough aeration.

I'm new to R2R and the responses I've received have been great. Should have joined sooner.:)
 
Deleted duplicate post
 
Last edited:
I decided to skip the test after reading glb's post.
You both lead me in the right direction- pretty sure inadequate aeration was issue with PH fluctuations. Last night opened my oveflow line choke valve a little to allow a little gurgle in my overflow box so air gets entrained in the water as it flows down to the first section of sump. Tested ph two hours later and it was 8.2. Checked again this morning before lights on and tested on + side of 8.2.

I had incorrectly assumed my skimmer provided enough aeration.

I'm new to R2R and the responses I've received have been great. Should have joined sooner.:)
We're all happy to help and glad you got it worked out.

I also ran my skimmers air intake line into the garage because there's not much C02 trapped in it and it did help the ph a little.
Some people run their skimmer air intake lines outside of their homes but you need to be careful that pesticides don't get sucked into those outside intake lines.

Bottom line we are all still learning and we are happy that you are apart of the R2R family.
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 32 45.7%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 12.9%
  • No.

    Votes: 26 37.1%
  • Other (please explain).

    Votes: 3 4.3%

New Posts

Back
Top