How do you change settings on an MP10?

[timrocks311]

Ok, this sounds like a stupid question but everytime I try to change settings on my MP10 it doesn't save it. I have two MP10s linked. They run in gyre mode alternating. I want to increase the speed a bit. If I hit set, turn it up, set, confirm the time, then set again, it doesn't change. It just stays with the same settings it's been at. What's the trick with these things? Thanks.

 

[Peace River]

Ok, this sounds like a stupid question but everytime I try to change settings on my MP10 it doesn't save it. I have two MP10s linked. They run in gyre mode alternating. I want to increase the speed a bit. If I hit set, turn it up, set, confirm the time, then set again, it doesn't change. It just stays with the same settings it's been at. What's the trick with these things? Thanks.

You may want to try to reset up the pumps including clearing the memory. Here is a link to EcoTech's MP10 instructions on Setting Up a Master Slave Relationship 2 Pump Configuration. Good luck!