How I Fixed my Apex Salinity Probe

[melonheadorion]

I would suggest to get a prob holder, instead of the prob sitting on the bottom. This will give you more flow around the probe. Second, I stop using my salinity probe as a measure, instead I watch and see if I have a jump or a decline in salinity.

If is have a fluctuation I use my bench top salinity check to really see were I am at.

thats exactly what i do as well.

 

[gbroadbridge]

Is that sold in the same isle as blinker fluid?

I'd suggest fixing the root cause of the problem.

 

[killer2001]

I think the solution to the bubble problem would be to get something that can hold the probe down in the tank, and then hold it in the water inversely... as in, the probe itself is pointing up.

 

[AydenLincoln]

Is that sold in the same isle as blinker fluid?

It really did help though especially with my AIO. And my probes have been good besides having to recalibrate it.

 

[All_talk]

From what I understand Temp compensation setup is critical, this might be worth a read.

(Almost) Everything You Need to Know About Apex Salinity Calibration and TC Factor

Apparently, the Same Module is a myth? Well, I change my R-pH to my Base Unit and Revert my CRx_pH to PM1. But TC on Base Probe & PM1 Probe is connected. Because when I turned TC of R-pH, my PM1 probe is automatically Enabled TC on its own. If I Disabled TC on PM1, the TC on Base Unit probe is...

www.reef2reef.com