How to wire 2-wire float switch?

[TCoach]

I have a Theiling Roller Mat on my tank. It uses a 2 wire mini float valve. When I initially let it run, it burned through the initial roll and most of what I saw was barely used mat.

Currently, I’m using a Kasa power strip to control it and have it running for 1min every 12 hours. Since I have been off this week for Christmas, I’ve noticed it starting to overflow between 10-12 hours and that running it for 5-10 seconds clears it.

I’d like to move it over to my P4 for control and trending based on the float switch triggering.

Basically, when the float switch triggers, I want to turn on the outlet until the float clears and 5 seconds pass or until 10 seconds pass on total run time.

Thoughts on how I can wire this into the P4 for control? Once it is wired in, I believe it will be a similar setup to my ATO.

Thanks,
-TCoach

(here is the float switch)

 

[Gaël]

Hello,

Please search a little before asking

Does anyone know the wiring of GHL Level sensors

Hey guys, Does anyone know the pinout of both the float and optical sensors for GHL? My understanding is Float use pin 1 & 2 (basically it's either open or shorted) - I need to confirm this with a multi meter (I have an OEM GHL float sensor). I am wondering what the pinpout for the Optical...

www.reef2reef.com

 

[SteveMM62Reef]

Sounds like the Roller Mat is getting Clogged. Couldn’t you just run it every Ten or Eight Hours, Rather than hacking into the Wiring, and having Salt intrusion getting into your wiring?

 

[BeanAnimal]

I would‘t call that hacking…

Instead of running on a timer and either wasting material or not using enough, why not automate it the way it should be? Though I thought that the unit was only supposed to advance based on the float anyway.

Afraid of salt creep? Heat Shrink tubing (the kind with glue inside for waterprofing or silicone filled wire nuts.