Hydros 2k & 4K Pumps stuck in override only mode

[Mppp]

My 2 linked pumps have been stuck in override mode since I last updated the firmware over a month ago. Everywhere I click is grayed out except to turn the two pumps off. In short, how to I "free" the pumps from override only mode?

 

[Mppp]

Also just went through 263 firmware update. No luck still except not as many screens are grayed out so I can update speeds for both pumps it appears, but when I go back to main screen it's stuck in "idle" for both pumps and if I click "max" it goes into override mode only again.

Followed firmware instructions on following Hydros link: https://www.coralvuehydros.com/product-support/hydros-control/updating-to-the-latest-firmware/

 

[Mppp]

I received an answer from Carlos at Hydros and all set now.


Your schedules were not configured correctly. You had the "Control Input" set to channel 1 when it should have been none. I changed it, and it started to work as soon as I uploaded the changes.

---
Sincerely,
Carlos C.