www.coralvuehydros.com
Don't power a wifi power strip with another power strip. They make standard power strips you can use. Just make sure whatever you use it will not get water spilled on it. They make devices you can use on your wall outlet that expands the number of outlets. You can usually get them at Lowes or Home Depot.
I have three solenoids hooked to Hydros 12v drive ports. They are for turning on water flow at my RODI though.
3 solenoids for RO/DI?
Yes, actually 4. one for the input feed to the RODI, one for the DI storage tank refill, one for the mix tank refill and one for flush bypass. The input one is powered off an AC transformer instead of a drive port.
That solenoid is for controlling CO2 to a calcium reactor. I am not sure if it will work on a CO2 scrubber or not.
I don't see why it wouldn't.
The one for the RO/DI and the DI storage tank serve the same function. Redundancy?
It is metal. Might be best to use the one for water in that application. Most pepole doing this want a 3/8" instead of 1/4".
Not really. All are controlled by my Hydros but the one on the input is turned on if either the one to refill the mix tank or the one for the DI tank refill is on. It also turns on once every hour for 10 minuted to refill the RO bladder for the fridge. The DI tank is automatically refilled if it goes low. If the fresh salt water tank goes low it is automatically refill with the mix tank if the mix tank is ready to use. Then it refills the mix tank with DI from the RODI unit automatically once it is low. When this happens it reset the ready state to not ready until I press a button to tell it it is ready to use again. So all I have to do is add the salt mix after the mix tank refills.
Correct! I want 3/8" instead of 1/4".
It wasn’t entirely clear, is this meant to be powered through the command bus connection? Or is there a hardwired outlet connection built into it? Would be awesome if I could reduce the amount of power strips needing to be plugged in
