Inkbird not working and BRS heater questions????

Fishingandreefing

2500 Club Member
View Badges
Joined
Nov 7, 2019
Messages
3,687
Reaction score
1,834
What state or country do you live in
Maryland
Rating - 0%
0   0   0
Got an Inkbird ITC 306A that kept displaying high temp at around 165 degree even though my bucket water is only 60 degree. When I go to setting to calibrate it, the max is 15 degree adjustment. I tried to reset it by pressing the decrease button then plug it in, but no beep nothing. Am I doing it wrong?

Also I am curious on the BRS titanium heater, if it runs without the temp controller, does it just keep heating to a point water is boiling or fail?

661C13BA-927F-4295-8E40-2D3F0148F62D.jpeg
 
It will keep heating. There's no thermostat on those heaters. Thus the reason a controller is needed
 
I would guess a bad probe or connection

The heater will heat continuously while plugged in
 
I would guess a bad probe or connection

The heater will heat continuously while plugged in
I am thinking that too. The probe do reacts to temp change as I hold it with my fingers and temp increased to 170 but I just need to either find another to reset it
 
Try disconnecting the temp prob and reconnecting. The proper way to calibrate the Inkbird is by using a glass of ice water and another trusted thermometer.
 
I'm not sure but you should try using Ranco temp controller. It's more accurate in controlling the temp. From what I understand, it's more high quality than Inkbird.
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 32 45.7%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 12.9%
  • No.

    Votes: 26 37.1%
  • Other (please explain).

    Votes: 3 4.3%
Back
Top