Intank Chamber 2 for Waterbox 10 won't fit...

  • Thread starter Thread starter Cell
  • Start date Start date
  • Tagged users None

Cell

10K Club member
View Badges
Joined
Apr 20, 2019
Messages
14,812
Reaction score
22,635
Rating - 0%
0   0   0
I recently purchased an intank Chamber 2 media basket for my Waterbox 10 and it won't fit. The bottom slides in pretty tight and about 3/4 of the way in, won't go in further unless I force it. I tried this once and could barely get it out. I measured it and it's about 1/16" wider on top than on bottom. I assume it's just a manufacturing defect and the plastic didn't get bent quite right. I purchased from and emailed Marine Depot about it and am awaiting a response. They might just kick it over to intank directly.

Anyone else ever have this issue with inTank media baskets?
 
The chambers in the AIO of the Waterbox are glued in by hand. It’s possibly that human error caused the baffles to be glued in at an angle which is preventing the intank chamber from fitting. I watched a YouTube video of someone with this exact same problem. What you need to do is cut along one of the seams of the intank chamber, cut off a thin strip and then superglue it back together again. It’s a straightforward DIY process. Luckily for my Waterbox 10 the baffles were glued in correctly.


This is the video. Good luck!
 
Yeah, I paid $43 for this. I shouldn't have to hack it apart and superglue it together to make it work. inTank needs to account for any manufacturer variation. If I have to cut apart and glue, I might as well just make my own.
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 30 44.8%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 13.4%
  • No.

    Votes: 25 37.3%
  • Other (please explain).

    Votes: 3 4.5%
Back
Top