Tank is finished cycling, so I did a 50% water change with water from my LFS. Then for good measure I checked my water parameters again and my salinity came in at 1.028 whereas before it was reading 1.025.
I have been testing with a coralife hydrometer and a few things bother me about it. The microbubbles on the needle that are impossible to get off. And the salt that dries on the inside of it and I can’t be sure of an accurate reading.
I went out and picked up a Hanna salinity tester from Facebook marketplace. Calibrated (twice with different packets of calibration fluid) and now the salinity reads 1.023
So now I need to bring the salinity up. Does anyone have any tips on it? The tank is empty since I did a fish less cycle.
13.5 Gallon Fluval Evo - stock everything
I have been testing with a coralife hydrometer and a few things bother me about it. The microbubbles on the needle that are impossible to get off. And the salt that dries on the inside of it and I can’t be sure of an accurate reading.
I went out and picked up a Hanna salinity tester from Facebook marketplace. Calibrated (twice with different packets of calibration fluid) and now the salinity reads 1.023
So now I need to bring the salinity up. Does anyone have any tips on it? The tank is empty since I did a fish less cycle.
13.5 Gallon Fluval Evo - stock everything


