Is this what I think it is??

@NervousReefer
I think your phosphate is ok (depending on coral) and your nitrate could be higher to eliminate bottoming out on either one of those two.


I hope you received my Zen Reefing comment on good faith as it was intended. Just yesterday, I begin following a forum thread: Zen Reefing and “A Question of Balance”. That coupled with nervous reefer brought on my Zen comment.
 
Last edited:
@NervousReefer
I think your phosphate is ok (depending on coral) and your nitrate could be higher to eliminate bottoming out on either one of those two.

I hope you received my Zen Reefing comment on good faith as it was intended. Just yesterday, I begin following a forum thread: Zen Reefing and “A Question of Balance”. That coupled with nervous reefer brought on my Zen comment.
Hey my name is NervousReefer lol but I’ve been working on not overreacting when I notice anything wrong with my tank. My OCD has been in overdrive since I’ve started in this hobby but this site has helped a lot and I’ve got to start not jumping the gun so much and letting things balance themselves out. Thank you for your input and quick replies it’s what I come here for :)
 
As it appears to be cyano, light and poor circulation are contributors. They respond to light in which when there’s reduced light, there is reduced cyano (same applies to Dino)
Cyanobacteria is a bacteria that is always present in our tanks. When it grows in enough numbers so it becomes visible & more physical it is because it has a food source allowing it to grow. That food source is primarily high levels of dissolved organic carbon compounds (DOCs). Cyano blooms or breakouts can be caused by just one or a combination of the following factors:

- Overfeeding

- Poor skimming - dirty or plain ole ineffective units

- Not using an RO water filter or you have an ineffective RO water filter, i.e., any brand not using a Filmtec membrane

- RO membrane not fully seated into it's housing allowing the water to bypass the membrane

- Infrequent water changes

- Improper filtration, i.e., sand bed not deep enough &/or too little rock

- Nutrients dumped from die-off on rocks during a cycle

- Liquid invertebrate and gelatin based foods - HIGH sources of DOC
 
As it appears to be cyano, light and poor circulation are contributors. They respond to light in which when there’s reduced light, there is reduced cyano (same applies to Dino)
Cyanobacteria is a bacteria that is always present in our tanks. When it grows in enough numbers so it becomes visible & more physical it is because it has a food source allowing it to grow. That food source is primarily high levels of dissolved organic carbon compounds (DOCs). Cyano blooms or breakouts can be caused by just one or a combination of the following factors:

- Overfeeding

- Poor skimming - dirty or plain ole ineffective units

- Not using an RO water filter or you have an ineffective RO water filter, i.e., any brand not using a Filmtec membrane

- RO membrane not fully seated into it's housing allowing the water to bypass the membrane

- Infrequent water changes

- Improper filtration, i.e., sand bed not deep enough &/or too little rock

- Nutrients dumped from die-off on rocks during a cycle

- Liquid invertebrate and gelatin based foods - HIGH sources of DOC
Only one of those sticks out and that’s skimming. My last skimmer just wasn’t skimming properly no matter the water height. I just replaced it a few days ago so we’ll see if that helps
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 32 45.7%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 12.9%
  • No.

    Votes: 26 37.1%
  • Other (please explain).

    Votes: 3 4.3%
Back
Top