Its leaking!! How do I stop it?

[john.m.cole3]

this is a MRC beckett skimmer. Its leaking above where the beckett screws in by about am inch.

 

[Nano sapiens]

It seems that your leak is not from a thread, correct? If not, silicone sealant might do the trick. Best to dry the area, thoroughly remove any dirt/other material and then apply the sealant. Read the label to determine the cure time (I usually wait a full 48 hours before wetting to allow for complete curing).

Good luck!

 

[john.m.cole3]

@cowboy got any ideas?

 

[mcarroll]

It's not clear from the pics....do you mean where the PVC meets the acrylic? (Have you confirmed the precise location yet?)

 

[mcarroll]

"How to stop the leak?"

Alternate answer:

Video - Doc Skimmer 9410

 

[justingraham]

If acrylic weld on 16 or four
If pvc new fitting or as someone stated silicone

 

[cromag27 Verified Sponsor]

Hey John did you get this fixed? I see what appears to be thread seal tape. that stuff should NEVER be used on plastic threads for waterproof purposes. is it leaking from the threads?