Jebao Power Adaptor Replacement

cdfjr1975 · Oct 16, 2018

I dropped my power adaptor in water briefly, thankfully I had it unplugged knowing I was working around water.

The case is not that solid since I heard water I the inside. Shook it until water came out and let it dry. Didn't have rice to put it in though.

I'm assuming I should replace the unit but I can't to find one.

Any suggestions!

Salt1972 · Oct 16, 2018

Take apart and rinse with RO/DI water and let it dry COMPLETELY. Blow it out with an air compressor and then let dry for 3-4 days with a fan. USUALLY, electronics will be OK, but no promises.

cdfjr1975 · Oct 17, 2018

Will give it a try. Thanks for the advice!

Salt1972 said:
Take apart and rinse with RO/DI water and let it dry COMPLETELY. Blow it out with an air compressor and then let dry for 3-4 days with a fan. USUALLY, electronics will be OK, but no promises.

wesman42 · Oct 17, 2018

cdfjr1975 said:
Will give it a try. Thanks for the advice!

Rinsing it with water is terrible advice. If you have rubbing alcohol, I recommend using rubbing alcohol to flush the water out. It evaporates much faster. THEN, get rice and set it in rice for a few days.