Jebao pp4 and 8

[Susan Edwards]

For my 45g tank that I'm reviving and getting it back to a "real" reef tank instead of a place to hold a solitary clown that can't go into the 240g, I just replaced my cheapie powerheads with jebaos pp4 and pp8 (later, mp10's). I'm doing this so I can put a rainbow bubble tip in there as soon as numbers are good. I'm looking for 3D printed guards for the rbta. I have mesh sleeves (for thread spools) or zipper mesh bags, but I'd rather put a real guard on them.

Does anyone make these or know someone who does? I checked etsy but they are not the pp model

 

[Peace River]

You may want to add a post to the 3D printing section here on R2R.

@Projects with Sam - any other thoughts about how Susan can get a 3D printed guard for her Jebao pumps?