Juwel trigon 350

[StephenMcn]

Juwel trigon 350
Vskim 800 powered by 3kdc sump pump and air pump
All pond solutions 350lph Surface skimmer
All pond solution 1000lph canister filter with uv sterilizer
3 blau wavemotion 8000
1 Maxspect gyre
Aquaone 90cm jbar
Ocean revive 120w led
Remote temp sensor with alarm set to 1degree celius differential
2x 400w heater
10kg live rock
20kg coral rock
Coral sand

 

[TheXpander]

This looks amazing! I’m in the process of setting up the Trigon 190, are you planning an auto top off at all? I’ve been thinking about it but not sure....

 

[StephenMcn]

This looks amazing! I’m in the process of setting up the Trigon 190, are you planning an auto top off at all? I’ve been thinking about it but not sure....

Hi. Thanks a million. I have an auto top of in the press still in box but I'm not finding much need to use it as my salinity stays pretty much the same(1.025) I was using the standard hud that came with tank until I started adding coral last saturday so I took the lid off and got 10mm perspex to cover it so as to let light penetrate through. As I do not have a sump I'm using a 1000lph canister. I have a v2 skim 800 in the original internal filter box and it's working great and I haven't that section covered which is allowing proper gas exchange with minimal evaporation. O2 levels constantly showing above 10

 

[Jmasonreef]

Very nice have to read up on these!

 

[StephenMcn]

Very nice have to read up on these!

It's just a hang on skimmer. I just couldn't hang it on as you know there corner tanks and a big skimmer hanging on the front wouldn't look great so I had to adapt and overcome as bear grills would say