Kamoer ATO One

[DarkReefer]

Hi all,

Over the weekend I installed a Kamoer ATO One. Seems to do it's job etc but I'm wondering if there's a better way I can set it up.
Is the top off designed to only fill up to the optical sensor?
I ask as I noticed tonight (after having played/moved the sensor around a little), that once the sensor is basically at the water height, it'll turn on briefly to squirt a small amount into the return chamber and then it'll go off again after the sensor touches the water once more (usually within a second or two). This results in the thing going off once every few minutes or so it seems?

Is there a way I can set this up to top off with more and get the water to a higher level before it needs to re-engage the ATO again? ie. over and above the sensor?

Thanks

 

[ReefRusty]

Mine is setup this way but doesn't go off to often. What is your temp set at?

 

[DarkReefer]

Mine is setup this way but doesn't go off to often. What is your temp set at?

It's at about 26 deg so not too warm or anything.
I haven't noticed it go off previously, but was tinkering around with it and must've just had a drop on the tip or something so it would fill suddenly for a second, then stop and a few minutes later go off again.
I moved it a little and hasn't done it again yet.

 

[ReefRusty]

Mine set to 25.7 so little cooler less evaporation, was away for 2 nights but my ATO Reservior was full and its now been 5 full days and was just under half way. Would last me 9-10 days

 

[DarkReefer]

Doesn't sound too bad then. I'll add some more into my reservoir in the next couple days maybe. Will continue to monitor as not too sure the usual usage as yet

 

[E.intheC]

Is anyone still running this ATO? I’m looking at options for my nano tank currently.