Kamoer X2SR how to adjust water levels

[Purplebirman]

Hi

I have a Kamoer X2SR which has been running great for a week, doing a small water change 4 times a day, and the ATO control is running fine too.

However, now I have reached the capacity of my water tanks, I have refilled the salt water and emptied the waste. The float switches on the app are showing correctly, but I can't work out how to tell it the reservoirs are full/empty and to stop the water level alarms/start the water change program again. I've read the manual and had a good play around with the app, rebooted it all etc but am still struggling.

Is there anyone with one of these that might be able to help me, please
Thank you

Purplebirman

 

[therootcause]

Select the wastewater container. Set volume to 37.0L and and hit OK. It should then reset. Same for Saltwater. Let me know if that didn't work.

 

[Purplebirman]

Select the wastewater container. Set volume to 37.0L and and hit OK. It should then reset. Same for Saltwater. Let me know if that didn't work.

Brilliant! Thank you, that worked! Don't know why they didn't make that more intuitive

 

[therootcause]

I know, nothing about it seems intuitive to me, but it does get the job done. How they couldn’t afford to have a native English speaker proof read the manual and HMI is ridiculous.

Another important note, the ATO does not function in manual mode. Sometimes I forget to switch back to plan mode and a day later my water level is dropping and salinity is up.

 

[Purplebirman]

Thanks for the tip about the ATO, I'll watch for that!

I kove it doing multiple water changes a day for me automatically, but I wish it was just a little more intuitive to set up!

 

[Dad Reefer]

Select the wastewater container. Set volume to 37.0L and and hit OK. It should then reset. Same for Saltwater. Let me know if that didn't work.

Tried this on my app, does not reset the volumes