Basically i ordered the kessil controler thats compatible with these old a360w lights. but i cant seem to find the right 0-10v connection they use to connect the two(Single light to controller). am i just missing something in plain sight or is anyone running a setup like this and have any insight on where to order this connection cable.
A360we tuna blue? And the Kessil A series controller?
If so, then it is just a standard 3.5mm audio cable or the standard Kessil cable. It is basically a stereo audio cable. The pin should have 3 sections, one for each channel and then a common ground. If it is a cable that also includes a channel for a mic, it will have issues, since the pins will not line up with the contact points on the cable end.
It would go like this once connected.
One end of audio cable or kessil cable to channel 1 or 2 on the controller
Other end to the "Input" on the light.
If you have 2 lights, then you would go from the output on the first light to the input on the second light.
Keep doing that from multiple lights.
Only 1 "feed" cable from either output on the controller is needed. After the first light the lights just daisy chain from light output to next light input.
After this is done, you can test it via manual mode on whatever output you used on the controller. If you used channel 1, then adjust channel 1 to all white and all blue. Make sure lights change color then do the same for brightness.
From there, you can setup your schedule based on the channel on the controller you used.
For reference. Channel One on controller is the left port. Power from micro USB is in the middle and channel 2 is the right port. All placement is when looking at screen on controller.
