AmatuerAuer
Active Member
- Joined
- Feb 23, 2015
- Messages
- 349
- Reaction score
- 50
I am installing a single 54w 48" system with two ATI bulbs. The wiring looks correct based on the diagram, but I am only getting a flash on one bulb and no response on the other. I have tried several combinations with no luck.. Can anyone out there help a guy out?
The outside blue wire goes to port #5 the outside red wire goes to port #2
The LET site says:
You plug in the ballast and one bulb flashes.
- In this case you most likely have an incorrectly wired end-cap or a defective bulb. If you have multiple kits set up and one of them is working correctly you can easily determine if you have a defective bulb by trying to fire the 'problem' bulbs in the working set-up. If both bulbs fire then you probably have a wiring problem. First verify that you have the correctly followed the wiring diagram included with your ballast. Then double check to make sure that you have wired each end-cap correctly. Re-fire. If you still are experiencing a problem, swap ballasts to verify that they are all working correctly. If both bulbs fire independently then you have a wiring problem.
The outside blue wire goes to port #5 the outside red wire goes to port #2
The LET site says:
You plug in the ballast and one bulb flashes.
- In this case you most likely have an incorrectly wired end-cap or a defective bulb. If you have multiple kits set up and one of them is working correctly you can easily determine if you have a defective bulb by trying to fire the 'problem' bulbs in the working set-up. If both bulbs fire then you probably have a wiring problem. First verify that you have the correctly followed the wiring diagram included with your ballast. Then double check to make sure that you have wired each end-cap correctly. Re-fire. If you still are experiencing a problem, swap ballasts to verify that they are all working correctly. If both bulbs fire independently then you have a wiring problem.
