Let's see your GHL!

buckroe07 · Jul 29, 2016

Here's mine! I just need to buy white cable grommets to place in the holes where the controller cords go through to finish it off

reef fish · Jul 30, 2016

D2MINI DO YOU KNOW THE GHL DOSER DIMENSIONS

reefwiser · Jul 30, 2016

Dimensions: 220 x 150 x 70 mm (without pumps)

reef fish · Jul 30, 2016

Do you know how much the heads stick out am make a box to slide is yours up and down this one is left to right thanks

mshur · Jul 30, 2016

Here is mine.
Profilux 3 with doser , 3 Power bars and other toys. I also use Mitras deep actinic light bars with T5 fixure.
2 Gyre pumps controlled by Profilux as well.

slief · Jul 31, 2016

reef fish said:
Do you know how much the heads stick out am make a box to slide is yours up and down this one is left to right thanks

If you are talking about the pump heads on the Doser 2, they stick out about 3/4" or 19mm. Also allow a bit of extra depth on the shelf for the cables (AC Power, PAB or USB). An extra couple inches would be a safe amount.

buckroe07 · Aug 1, 2016

mshur said:
I also use Mitras deep actinic light bars

Where did you purchase these from?!

Janci · Aug 1, 2016

mshur said:
Here is mine.
Profilux 3 with doser , 3 Power bars and other toys. I also use Mitras deep actinic light bars with T5 fixure.
2 Gyre pumps controlled by Profilux as well.

How do you like the mitras light bar?
Was doubting to add an Actinic or Deep Actinic to my T5 fixture.
Not sure if it is worth it.

mshur · Aug 31, 2016

buckroe07 said:
Where did you purchase these from?!

GhlUSA.com

mshur · Aug 31, 2016

Janci said:
How do you like the mitras light bar?
Was doubting to add an Actinic or Deep Actinic to my T5 fixture.
Not sure if it is worth it.

Love it as a supplement to T5s. I was between Reef Brights and Mitras but decided on Mitras for better control specially with Profilux

TerminalShck · Sep 1, 2016

slief said:
I have a fairly big setup (480G display, 60g display refugium and 650g overall volume). My equipment spread all over the place to accommodate the locations of various things in my system. As a result, I have limited mounting options. I had to mount mine on one of the walls next to one of the doors below the tank. I wish I had a better place to mount the controller but it needed to be close to my sump for the probes and couldn't be mounted directly under the tank due to my reactors being hung under there along with my manifold valves and such. This worked out fine since I really don't have to interface with the main controller as the Touch tells me everything I need to know and GCC is my main interface.

I mounted my Profilux touch in an accessible place though. It's mounted to my display refugium which happens to be illuminated by a Mitra 6200. Sorry about the terrible picture. It's hard to get a good one due to the power of the Mitra..

I always enjoyed your system Scott