Leveling a reefer xl 300 G2 help please.

exnisstech · Feb 17, 2023

Just setting this up and have it all level dry so subject to change once filled. My question is what majic tool do you use to adjust the feel on the center support running front to rear. The center feet on the outside edges were not contacting the floor so I am assuming the ones in the center support may not be either but I can't get to them to even check them.

Kactai · Feb 22, 2023

Bump!

I’ve got a Waterbox Infinitia 275.6 and have the same type of problem. There are 7 levelling feet along the back wall of the tank…. Only two of which I can reach with a 4” gap between the tank and wall. How would you even adjust and level your tank once on the stand? How would you ensure the other legs are touching the ground and ensure they are doing their part to support the tank?

jabberwock · Feb 22, 2023

Find any level spot with good access to the adjustable feet. Level the tank. Go to where the tank will be. Check the floor for level, work your way up the stand until you have the top of the stand stand level. Leveled tank should sit on the top of the stand leveled with minimal adjustments. You have to do it incrementally from a known dead level space.

exnisstech · Feb 22, 2023

Kactai said:
Bump!

I’ve got a Waterbox Infinitia 275.6 and have the same type of problem. There are 7 levelling feet along the back wall of the tank…. Only two of which I can reach with a 4” gap between the tank and wall. How would you even adjust and level your tank once on the stand? How would you ensure the other legs are touching the ground and ensure they are doing their part to support the tank?

I fugured it out. And I'm goofy and didn't realize this was my thread du. Yours sounds similar to the redsea stand I just set up. I had to remove the board inside where the sump sits to get to all the leveling feet from the inside then reinstall that board. I also filled the tank half full to make sure it was level with weight on the stand.
I always place the level on the tank and shim or adjust. I've not had good luck leveling the stand then placing the tank.