Leveling tank stand

[sergifed91]

I was setting up my stand to level it. I couldn't figure out why it just wouldn't level. After
About an hour of struggling with it. I Decided to download a level app to my phone. I retook the shames out and was able to level it with ease. Has anyone else tried
A leveling app in their phone?

 

[lapin]

Roofers use it all the time for level and angles

 

[amsterdam_reefer]

Roofers use it all the time for level and angles

If you take the width side 1st and then the length 2nd then the other width as 3rd youre good to go

 

[sergifed91]

If you take the width side 1st and then the length 2nd then the other width as 3rd youre good to go

After I got the leveling app. And leveled it out width and length. I couldn't get it leveled. Most offby.1 on width and length.

 

[amsterdam_reefer]

After I got the leveling app. And leveled it out width and length. I couldn't get it leveled. Most offby.1 on width and length.

You can better buy a level for accuracy
Only level the outsides the 4 corners the rest is stuctural support
If u start left raise the on that needed to raise from the point u raised u go right and raise that one then go right and raise the last one
The rest u raise till a little pressure is felt

 

[Ramdude4G]

I wouldn’t worry too much about the cross braces. You could, once you get the stand level, use wedge type shims and slide those under the front and rear runners at those points. Slide them in till snug and tap a little more with a hammer and cut flush. Help this helps.

 

[DaddyFish]

First rule of leveling should always be flip the tool around 180-degrees and recheck. No mechanical level is ever perfect.
I'll have to give the app a try!

 

[amsterdam_reefer]

I think u can better use an old school level or re measure with one to be sure that the gyroscoop is not malfuncioning

Why cheap options if u put a thousends of dollars in a tank