Levels High After Water Change

Did you prime it and make sure all the air is out of the system? Did it come with foam to go around the outlet?
Didn’t come with any foam no. I could probably cut a couple strips of filter floss and put it inside the outlets. It makes great foam! But haven’t run it long enough to collect anything from it.
 
Here is what I was talking about. The tube that feeds back into my tank has a couple rings around it
 

Attachments

  • 16130895386731022813490565459589.jpg
    16130895386731022813490565459589.jpg
    210.1 KB · Views: 50
So yesterday I did a 20% water change on my 30 gallon. All I have is rock, sand and two clown fish. This is going on my 4th week. When I started the tank I used TurboStart 900, and have monitored my chemistry daily. Ammonia has so far always been 0 as has been Nitrite, with just a tiny nitrate.

Yesterday
Ammonia .50ppm
Nitrite 2.0ppm
Nitrate 5ppm
PH 8
Salinity 1.025

Today 24 hours after my 20% water change:
Ammonia 1ppm
Nitrite 1ppm
Nitrate 20ppm
PH 8
Salinity 1.025

Should I do another water change but bigger? Or should I let it go and see what my chemistry is tomorrow? Could I maybe be in the middle/tail end of a cycle

Any tips/advice are welcome!
I think your salt has ammonia, sorry
 
its when your salt ahs ammonia sometimes its naturally collected sometimes its added, what matters is that its something what type of salt do you have?
Oh, I use Fritz RPM. My tank is great now. Eased up on feeding a little. Now I have 0 ammonia, 0 nitrates, just a bit of nitrate.
 

IF YOU HAD TO TAKE A REEFING EXAM, WOULD YOU PASS?

  • Yes!

    Votes: 32 45.7%
  • Not yet, but I have one that I want to buy in mind!

    Votes: 9 12.9%
  • No.

    Votes: 26 37.1%
  • Other (please explain).

    Votes: 3 4.3%
Back
Top