Loose mushroom solution

[TheKylersFire]

Hey guys I remember seeing at a Macna a few years ago a 3D printed cap that had a grid pattern that goes over a frag plug that’s meant to keep loose mushrooms on a Frag plug. Anyone ever try these or have any luck with these?

Does anyone know where to snag one?

Thanks

 

[ReefGrammie]

I haven't tried anything like that, but a rubber band will also work (just not too tight) in a crisscross pattern. I have also put loose rubble in a clear plastic container in the tank in a low-flow area and let the mushroom attach itself to a rock. I check it in a week or so and it has usually attached itself by then.

 

[najer]

Have a look here.

3d Printed Aquarium Parts Archive Thread

With all the different things being made and shared in the 3d printing world it can be really hard to find what is even available to us reefers. To help remedy that I thought I'd start an archive thread of all the 3d printed freely available parts I am able to find. This is only for parts that...

www.reef2reef.com