I currently have slightly low alkalinity between 6.4 and 7 and high calcium (a little over 500). Things in the reef are thriving. I have heard you can set the reactor for the desired alkalinity and the calcium will fall into proper range since it’s all about balance. pH is fine (maybe a little low at 8.1) but hesitant to do anything about it since corals, fish and inverts and everything are healthy and happy. Reason I’m asking is I’d like the alkalinity to be higher just on personal preference and the alkalinity to be lower. Is it possible the reactor size in an issue as it’s a relativiely small one for the 140 gallon tank? IE if I was to go with a bigger reactor would the alkalinity and calcium fall into where I want them to be?
Low alkalinity high calcium with Reactor
- Thread starter Buh Buh Bacon
- Start date
- Tagged users None
Brew12
Electrical Gru
Did you have everything in balance when you put the reactor online?
GoVols
Cobb / Webb - 1989
Reef Squad Leader
Excellence Award
Reef Tank 365
MTRCMember
Article Contributor
Hospitality Award
R2R Research
My Tank Thread
Welcome to Reef 2 Reef.
I caught an article about balancing out cal to alk with a cal calcium reactor and it had some of Randy's quotes in it.
It said that one thing to look at was to make sure that your reef as not lower than .35ppt in salinity, when running a cal reactor.
I caught an article about balancing out cal to alk with a cal calcium reactor and it had some of Randy's quotes in it.
It said that one thing to look at was to make sure that your reef as not lower than .35ppt in salinity, when running a cal reactor.
The high calcium is probably coming from your salt mix and is kept extra high due to water changes. I have that same issue. Currently using RC which tests over 490 freshly mixed. When my current supply runs out I'm switching to a salt with less calcium.
As far as I know, it's normal for levels to go out of whack over longer periods of time. Corals, inverts, and other things depending on calcium & carbonate don't necessarily uptake the same ratio of alk/cal as the reactor spits out. Also, check your Magnesium level, if you haven't already.
This I believe.
GoVols
Cobb / Webb - 1989
Reef Squad Leader
Excellence Award
Reef Tank 365
MTRCMember
Article Contributor
Hospitality Award
R2R Research
My Tank Thread
@dimo @saltyfilmfolks
Good point.
I do use a salt mix that mixes to my reef's (and cal reactors) parameters, at .35ppt
Good point.
I do use a salt mix that mixes to my reef's (and cal reactors) parameters, at .35ppt
Randy Holmes-Farley
Reef Chemist
Staff member
Super Moderator
Excellence Award
Expert Contributor
Article Contributor
R2R Research
My Tank Thread
What media are you using?
If it is lower in magnesium than the calcium carbonate that is being deposited in your tank, high calcium will result long term, just as it does dosing limewater/kalkwasser for calcium and alkalinity.
If it is lower in magnesium than the calcium carbonate that is being deposited in your tank, high calcium will result long term, just as it does dosing limewater/kalkwasser for calcium and alkalinity.
