Maxspect Gyre Question

[denverjon]

I need some advice...I've got two Maxspect 350's on opposite sides of 250g. I've got an island on each end, one has a lot of softies while the other is sps dominant. I like have the random flow on my sps and the pulse mode on my softies but when I run those settings, I get a lot of turbulence in the middle of my tank, which is where most of goni's and euphyllia are located. Ideally, I'd like them to alternate so I don't get all of that turbulence but can't figure if there's a way to do that. Any help would be appreciated!

 

[denverjon]

bump

 

[Crashnt24]

Do you have the icv6? I'm only familiar with using that to control the pumps. I know you can anti sync certain flow patterns using the app

 

[denverjon]

No, I don't have an icv6. I'm surprised you can't program it to alternate.

 

[Crashnt24]

There should be a way using the controller. Can't say for sure though, I never tried it. I just went straight to the icv6. Hopefully someone here can chime in, otherwise I believe support at coralvue is knowledgeable on maxspect equipment.

 

[Taka]

There is the Maxspect forum on R2R. Maybe you can try to post your problem there so that their cutomer service can find your thread quickly.

 

[Bryknicks]

Run the anti-sync mode on their controller