Monitoring Oxygen - How many of you do it.

[FBAA]

So I had an incident recently. I run a custom anaerobic digester that gets dosed sugar and controls my nitrates/phosphates/sulfates. The dosing pump failed and overdosed the system. I noticed the tank getting foggy from a bacterial bloom and did some testing. The fish were obviously stressed. After testing I found the oxygen level bottomed out. I added a lot of carbon bags and a couple of pumps to aerate the system and everything recovered fairly quickly except I did lose 1 fish.

Does anyone here use an oxygen monitor? I have a pinpoint that I use occasionally but only to solve problems. The Neptune system, while impressive, is way overpriced IMHO. I might spend the money on it in the future but after reefing for 25+ years without something like that it makes me wonder if it's worth it.

 

[ca1ore]

I do use the apex PM3 plus O2 probe. Mostly useless frankly, and certainly not worth the price. It's hard to keep the probe in calibration. Most annoyingly, Neptune don't sell the electrolyte separately and the one small bottle in the membrane replacement kit is enough for one, maybe two, replacements. they were completely unhelpful when I inquired. Waste of time and a hard pass!

 

[FBAA]

Good to know. Thank you. For my situation I may need to monitor because I am dosing anaerobics.

 

[reefeer14]

I use the seneye reef monitor. not cheap but not crazy expensive either. measures:

oxygen
ph
temp
water level
ammonia
par

i have it plugged into my computer which is near my tank so I can check readings using my smartphone.

nifty little device. only downside is that you need to replace a slide in the unit every month. slides cost about $11 but you can find them on amazon.

seneye Reef - seneye

The seneye Reef allows you to monitor multiple parameter, this 8 in 1 aquarium monitor for your life-critical parameters is reliable and accurate with the seneye forecast engine can tell you before there is a problem. The Full light meter monitors PAR, LUX and Kelvin to keep your corals healthy...

www.seneye.com

 

[AJsReef]

I use the seneye reef monitor. not cheap but not crazy expensive either. measures:

oxygen
ph
temp
water level
ammonia
par

i have it plugged into my computer which is near my tank so I can check readings using my smartphone.

nifty little device. only downside is that you need to replace a slide in the unit every month. slides cost about $11 but you can find them on amazon.

seneye Reef - seneye

The seneye Reef allows you to monitor multiple parameter, this 8 in 1 aquarium monitor for your life-critical parameters is reliable and accurate with the seneye forecast engine can tell you before there is a problem. The Full light meter monitors PAR, LUX and Kelvin to keep your corals healthy...

www.seneye.com

Worth noting the Seneye “oxygen” reading is entirely hypothetical and a calculation based on other observed parameters of the unit vs literal dissolved oxygen probe… Very debatable if Seneyes “oxygen” reading is even worthy for anything.

 

[Roosterjack]

Always wondered about the Apex Oxygen probe...glad to know your experiences with it.

 

[mucky1957]

Salifert Oxygen test kit

 

[littlebeard]

How's your DIY game? Atlas scientific has some nice probes.

Lab Grade Dissolved Oxygen Probe | Atlas Scientific

The Atlas Scientific Lab Grade Dissolved Oxygen probe is a durable little probe that can work in almost any environment.

atlas-scientific.com

I DO not have this probe, but I do run their temperature and PH probes which I hooked up to a raspberry pi via the tentacle . No soldering required, however it did require me to change the ezo circuit modes.

I have debated their salinity and Dissolved oxygen probes but I just end up spending my money on corals instead.