Bustyraker
Well-Known Member
My mp10 stopped working and flashes red. I've had it flash red and green before but this time it just flashes red and a lighter red. If I unplug it the pump runs for a second and then shuts down.
Mp 10 flashing red/red. Not red and green.
- Thread starter Bustyraker
- Start date
- Tagged users None
redfishbluefish
Stay Positive, Stay Productive
Staff member
Super Moderator
Reef Squad
Partner Member 2024
Excellence Award
Article Contributor
NJRC Member
Hospitality Award
No promises, but try a full factory reset. First remove the wet side and then follow the steps below:
1) With the controller powered on, press and hold the "Mode" and "Set" buttons until the dial blinks Red, White and Blue.
2) Press and hold the "Mode" button until dial blinks Red and Purple.
3) Press and Hold the "Mode" and "Power/Option" buttons until the pump powers off and resets.
Hope this helps.
1) With the controller powered on, press and hold the "Mode" and "Set" buttons until the dial blinks Red, White and Blue.
2) Press and hold the "Mode" button until dial blinks Red and Purple.
3) Press and Hold the "Mode" and "Power/Option" buttons until the pump powers off and resets.
Hope this helps.
