I have an older MP10 wES (out of warranty) that stopped changing modes or speeds. If I hold the Mode button down, it does go into feed mode and if I hold longer, it does power off, so the button does work. I am also able to hard reset it, so all the buttons do work. However, I am unable to change modes and I am unable to change speeds. When I press the Mode button, it just stays at the constant green mode and when I rotate the dial, it doesn't do anything. Any suggestions? I've already hard reset it a few times.
MP10wES Doesn't change Modes or Speeds
- Thread starter puffy127
- Start date
- Tagged users None
Crabs McJones
I'm so shi-nay
Excellence Award
Reef Tank 365
Article Contributor
Moderator Emeritus
Hospitality Award
Reef Tank 365 Boss
Wisco Reefers
My Tank Thread
Did it somehow accidentally get put into slave mode? What hard reset procedure did you do?
Clear Driver Memory - The internal memory of
each unit must be cleared before setting up a
group. Hold MODE and SET together until the
control dial blinks red/white/blue. Then hold MODE
until the dial blinks red/purple. Then hold SET until
the pump resets.
Clear Driver Memory - The internal memory of
each unit must be cleared before setting up a
group. Hold MODE and SET together until the
control dial blinks red/white/blue. Then hold MODE
until the dial blinks red/purple. Then hold SET until
the pump resets.
Crabs McJones
I'm so shi-nay
Excellence Award
Reef Tank 365
Article Contributor
Moderator Emeritus
Hospitality Award
Reef Tank 365 Boss
Wisco Reefers
My Tank Thread
Hmm, only other thing I can think of is, do you have a battery backup connected to your pump? If so if you remove it does the pump return to normal?
