Mp10wES help.

[cjtabares]

I have an old MP10wES that seems to stall when connected to the wet side. It will run when it is not connected to the wet side, I tried 2 wet sides, and it stalls with both. I have connected both wet sides, to my other dry side and they work. I hope that makes sense. Is there anything I can do, or try to get it working? Thanks for any ideas.

 

[ReefStable Verified Sponsor]

Sounds like the magnet inside the dry Side is pulling forward or there is too much friction when it spins.

A temporary option is to use a thicker spacer to weaken the pull. But it might not work.

The long term solution is to contact EcoTech and see if there is a grease that needs replacing or any troubleshooting steps they have to narrow down the exact problem.

 

[cjtabares]

Sounds like the magnet inside the dry Side is pulling forward or there is too much friction when it spins.

A temporary option is to use a thicker spacer to weaken the pull. But it might not work.

The long term solution is to contact EcoTech and see if there is a grease that needs replacing or any troubleshooting steps they have to narrow down the exact problem.

Ok, thanks. I will reach out to them.